Features

• 300 watts of charging power
• Adjustable float voltage
• Buck topology
• Two stage Charging
• Common negative design
• Three year warranty (parts & labor)
• Product Datasheet | Download
• Product Manual | Download
• Mechanical Drawing | Download
• Parasolid (x_t) file | Download

The BCD300 battery charger outputs up to 300 watts to charge a 12V or 24V battery system (1 or 2 banks) from any higher voltage between 20 and 45 volts. The source and the batteries under charge must share a common ground. Multiple stages of filtering reduce radiated or conducted noise to very low levels.

The two stage charging profile charges the batteries at a constant current until the battery voltage reaches the float voltage that the unit is set to and then the current into the batteries will taper off as necessary to maintain the batteries at the float voltage.

The unit can be left permanently connected without fear of overcharge or damage to the batteries. The adjustable float voltage feature allows the unit to be used for any type of lead-acid battery including lead acid and gel cell.

Function	Battery Charger
Conversion	DC to DC
Power Level	300
Input Volts	30 - 45 VDC
Output Volts	24 VDC
Output Amps Continuous	20
Input/Output Isolation	No
Technology	Analog
Charging Stages	2
Temperature Compensation	No
Equalize	No
Battery Banks	2
Product Series on website	BCD300
Option Codes	'Z' No Conformal Coating (Any Model), 'X' Ruggedized & Wide Temp, 'O' Open Frame - No chassis, 'M' Military Rugged, 'J' MIL810 Tested Only, 'I' MIL461 Tested Only, 'F' Electric Fork Lift, 'G' GMDSS (DVAM & RCP1 Remote), 'E' European ROHS compliant, 'C' MIL461F & MIL810G Tested

Product Reviews